Does the Mitsubishi L200 have more brake problems than other vans its age?

Mitsubishi L200s have brake problems recorded about as often as other vans their age.

per 100 tests
20.54 per 100 testsdefects recorded at first MOT tests

Expected for vans of the same age: 19.89 per 100 tests

One test can record several defects, so this is not the share of Mitsubishi L200s.

Data: DVSA MOT results · 2019–2024 · 539,553 tests

Check a Mitsubishi L200 by registration

How often do brake advisories on Mitsubishi L200s turn into fails?

16.6% of brake advisories on Mitsubishi L200s turned into brake fails at the next MOT.

Typically, the next MOT came 12 months and 5,701 miles later.

Based on 116,642 advisories, each followed to the car's next MOT, 2019–2024. This counts advisories, not cars.

Which brake problem is recorded most on the Mitsubishi L200?

Brake pipe rusted or damaged: recorded 46,147 times in 2019–2024, or 8.55 per 100 tests.

A metal brake pipe is badly rusted or damaged and could leak brake fluid, which fails the MOT.

What to check: Look along the underside at the metal brake pipes for flaking rust, and ask whether they were renewed.

Check a Mitsubishi L200 by registration

For example, AB12 CDE

Before you submit. Enter a UK registration to compare this vehicle with similar cars: statistical information, not vehicle condition advice. It goes to the DVSA MOT History API, never into URLs or analytics, and any cache expires within 15 minutes. MOT history is free on GOV.UK and we do not sell it; read how we use your data.

Free to use. Independent site. Not affiliated with DVSA, DVLA or GOV.UK.

Which brake problems should I check for on a used Mitsubishi L200?

The brake defects recorded most often on Mitsubishi L200s, 2019–2024, per 100 tests.

  • Brake pipe rusted or damaged8.55
    Major

    What to check: Look along the underside at the metal brake pipes for flaking rust, and ask whether they were renewed.

  • Brake pads or shoes dangerously thin2.26
    Dangerous

    What to check: Look through the wheels at the pads and discs, listen for grinding, and ask when they were last replaced.

  • Brake dragging when released1.16
    Major

    What to check: Check the car rolls freely when coasting and does not pull to one side.

  • Uneven braking side to side1.10
    Major

    What to check: Brake firmly on a quiet straight road and check the car stops in a straight line.

  • ABS or brake warning light on0.69
    Major

    What to check: Check the ABS light goes out after start-up and stays out on the test drive.

One test can record several defects, so this is not the share of Mitsubishi L200s.

Each tip applies only if the car you are looking at has that fault in its own MOT history.

All DVSA descriptions in this group (5)
Mitsubishi L200: brake defects recorded at MOTs, 2019–2024, 30 or more each
DVSA descriptionIn plain wordsRecordedPer 100 tests
Brake pipe damaged or excessively corrodedBrake pipe rusted or damaged46,1478.55
a brake lining or pad worn below 1.5mmBrake pads or shoes dangerously thin12,1982.26
Significant brake effort recorded with no brake applied indicating a binding brakeBrake dragging when released6,2521.16
Brakes imbalance across an axle such that the braking effort from any wheel is less than 70% of the maximum effort recorded from the other wheel on the same axle.Uneven braking side to side5,9161.1
Warning device shows system malfunctionABS or brake warning light on3,7480.69

Download these figures (CSV)

How are these figures calculated?

Defects are counted at first MOT tests, 2019–2024. The expected rate is for vans with the same mix of ages.

The comparison uses 539,553 initial tests. The difference is +0.65 defects per 100 tests (95% interval +0.53 to +0.77).

Full methodology

How to cite these figures

Download the full dataset (CSV) · All models on brakes