Does the MG TF have more suspension problems than other cars its age?

MG TFs do have suspension problems recorded, but less often than other cars their age.

per 100 tests
19.79 per 100 testsdefects recorded at first MOT tests

Expected for cars of the same age: 31.88 per 100 tests

One test can record several defects, so this is not the share of MG TFs.

Data: DVSA MOT results · 2019–2024 · 66,673 tests

Check an MG TF by registration

How often do suspension advisories on MG TFs turn into fails?

17.6% of suspension advisories on MG TFs turned into suspension fails at the next MOT.

Typically, the next MOT came 12 months and 1,418 miles later.

Based on 12,172 advisories, each followed to the car's next MOT, 2019–2024. This counts advisories, not cars.

Which suspension problem is recorded most on the MG TF?

Worn suspension bush or joint: recorded 3,350 times in 2019–2024, or 5.02 per 100 tests.

A suspension bush, pin or ball joint has worn loose, which makes the handling vague and fails the MOT.

What to check: Listen for knocks over speed bumps, feel for the car wandering under braking, and ask which part was replaced.

Check an MG TF by registration

For example, AB12 CDE

Before you submit. Enter a UK registration to compare this vehicle with similar cars: statistical information, not vehicle condition advice. It goes to the DVSA MOT History API, never into URLs or analytics, and any cache expires within 15 minutes. MOT history is free on GOV.UK and we do not sell it; read how we use your data.

Free to use. Independent site. Not affiliated with DVSA, DVLA or GOV.UK.

Which suspension problems should I check for on a used MG TF?

The suspension defects recorded most often on MG TFs, 2019–2024, per 100 tests.

  • Worn suspension bush or joint5.02
    Major

    What to check: Listen for knocks over speed bumps, feel for the car wandering under braking, and ask which part was replaced.

  • Suspension part rusted or damaged4.83
    Major

    What to check: Look under the car at the suspension arms and anti-roll bar for flaking rust, or bends from hitting a kerb.

  • Rust near suspension or subframe mounts4.26
    Major

    What to check: Look under the car around the suspension mountings for rust holes, patch welds or fresh underseal hiding rust.

  • A suspension component fractured or likely to fail0.82

    What to check: Ask the seller what was repaired, and when.

  • Wheel bearing with play0.80
    Major

    What to check: Ask whether the bearing was replaced, and listen for a hum or growl that rises with speed on the test drive.

One test can record several defects, so this is not the share of MG TFs.

Each tip applies only if the car you are looking at has that fault in its own MOT history.

All DVSA descriptions in this group (5)
MG TF: suspension defects recorded at MOTs, 2019–2024, 30 or more each
DVSA descriptionIn plain wordsRecordedPer 100 tests
A suspension pin, bush or joint excessively wornWorn suspension bush or joint3,3505.02
A suspension component excessively damaged or corrodedSuspension part rusted or damaged3,2184.83
The strength or continuity of the load bearing structure within 30cm of any sub-frame, spring or suspension component mounting (a 'prescribed area') is significantly reduced or inadequately repairedRust near suspension or subframe mounts2,8374.26
A suspension component fractured or likely to failA suspension component fractured or likely to fail5480.82
A wheel bearing with excessive playWheel bearing with play5310.8

Download these figures (CSV)

How are these figures calculated?

Defects are counted at first MOT tests, 2019–2024. The expected rate is for cars with the same mix of ages.

The comparison uses 66,673 initial tests. The difference is −12.09 defects per 100 tests (95% interval −12.52 to −11.66).

Full methodology

How to cite these figures

Download the full dataset (CSV) · All models on suspension