Does the Rover 216 have more suspension problems than other cars its age?
Rover 216s do have suspension problems recorded, but less often than other cars their age.
- per 100 tests
- 16.7 per 100 testsdefects recorded at first MOT tests
Expected for cars of the same age: 23.26 per 100 tests
One test can record several defects, so this is not the share of Rover 216s.
Data: DVSA MOT results · 2019–2024 · 6,372 tests
Check a Rover 216 by registration
How often do suspension advisories on Rover 216s turn into fails?
14.9% of suspension advisories on Rover 216s turned into suspension fails at the next MOT.
Typically, the next MOT came 12 months and 1,449 miles later.
Based on 952 advisories, each followed to the car's next MOT, 2019–2024. This counts advisories, not cars.
Which suspension problem is recorded most on the Rover 216?
Rust near suspension or subframe mounts: recorded 484 times in 2019–2024, or 7.60 per 100 tests.
The metal near a suspension, spring or subframe mounting is badly rusted, damaged or poorly repaired, which fails the MOT.
What to check: Look under the car around the suspension mountings for rust holes, patch welds or fresh underseal hiding rust.
Check a Rover 216 by registration
Which suspension problems should I check for on a used Rover 216?
The suspension defects recorded most often on Rover 216s, 2019–2024, per 100 tests.
- Rust near suspension or subframe mounts7.60Major
What to check: Look under the car around the suspension mountings for rust holes, patch welds or fresh underseal hiding rust.
- Worn suspension bush or joint4.65Major
What to check: Listen for knocks over speed bumps, feel for the car wandering under braking, and ask which part was replaced.
- Suspension joint cover perished0.83Minor
What to check: Look at the ball joint covers behind the front wheels: once a cover splits, the joint wears out.
- Suspension part rusted or damaged0.78Major
What to check: Look under the car at the suspension arms and anti-roll bar for flaking rust, or bends from hitting a kerb.
- Shock absorber leaking or failed0.72Major
What to check: Look behind the wheels for oily, wet shock absorbers, and push down hard on each corner: it should rise once and settle.
One test can record several defects, so this is not the share of Rover 216s.
Each tip applies only if the car you are looking at has that fault in its own MOT history.
All DVSA descriptions in this group (5)
| DVSA description | In plain words | Recorded | Per 100 tests |
|---|---|---|---|
| The strength or continuity of the load bearing structure within 30cm of any sub-frame, spring or suspension component mounting (a 'prescribed area') is significantly reduced or inadequately repaired | Rust near suspension or subframe mounts | 484 | 7.6 |
| A suspension pin, bush or joint excessively worn | Worn suspension bush or joint | 296 | 4.65 |
| A suspension joint dust cover severely deteriorated | Suspension joint cover perished | 53 | 0.83 |
| A suspension component excessively damaged or corroded | Suspension part rusted or damaged | 50 | 0.78 |
| A shock absorber damaged to the extent that it does not function or showing signs of severe leakage | Shock absorber leaking or failed | 46 | 0.72 |
How are these figures calculated?
Defects are counted at first MOT tests, 2019–2024. The expected rate is for cars with the same mix of ages.
The comparison uses 6,372 initial tests. The difference is −6.56 defects per 100 tests (95% interval −7.75 to −5.38).
More on the Rover 216
- Overview:
- Model overview · All Rover models
- What fails:
- body · brakes · plates · lights · emissions · seat belts · steering · suspension · tyres · visibility
- By area:
- Postcode areas
- Similar cars on suspension:
- Toyota Vitz · Toyota Camry
- Group ranking:
- All cars on suspension