Does the LDV Convoy have more suspension problems than other vans its age?

LDV Convoys do have suspension problems recorded, but less often than other vans their age.

per 100 tests
35.4 per 100 testsdefects recorded at first MOT tests

Expected for vans of the same age: 41.47 per 100 tests

One test can record several defects, so this is not the share of LDV Convoys.

Data: DVSA MOT results · 2019–2024 · 5,768 tests

Check an LDV Convoy by registration

How often do suspension advisories on LDV Convoys turn into fails?

19.5% of suspension advisories on LDV Convoys turned into suspension fails at the next MOT.

Typically, the next MOT came 12 months and 2,032 miles later.

Based on 1,316 advisories, each followed to the car's next MOT, 2019–2024. This counts advisories, not cars.

Which suspension problem is recorded most on the LDV Convoy?

Rust near suspension or subframe mounts: recorded 990 times in 2019–2024, or 17.16 per 100 tests.

The metal near a suspension, spring or subframe mounting is badly rusted, damaged or poorly repaired, which fails the MOT.

What to check: Look under the car around the suspension mountings for rust holes, patch welds or fresh underseal hiding rust.

Check an LDV Convoy by registration

For example, AB12 CDE

Before you submit. Enter a UK registration to compare this vehicle with similar cars: statistical information, not vehicle condition advice. It goes to the DVSA MOT History API, never into URLs or analytics, and any cache expires within 15 minutes. MOT history is free on GOV.UK and we do not sell it; read how we use your data.

Free to use. Independent site. Not affiliated with DVSA, DVLA or GOV.UK.

Which suspension problems should I check for on a used LDV Convoy?

The suspension defects recorded most often on LDV Convoys, 2019–2024, per 100 tests.

  • Rust near suspension or subframe mounts17.16
    Major

    What to check: Look under the car around the suspension mountings for rust holes, patch welds or fresh underseal hiding rust.

  • Worn suspension bush or joint3.55
    Major

    What to check: Listen for knocks over speed bumps, feel for the car wandering under braking, and ask which part was replaced.

  • A king pin loose in the axle beam2.96

    What to check: Ask the seller what was repaired, and when.

  • Shock absorber leaking or failed2.53
    Major

    What to check: Look behind the wheels for oily, wet shock absorbers, and push down hard on each corner: it should rise once and settle.

  • Wheel bearing with play1.80
    Major

    What to check: Ask whether the bearing was replaced, and listen for a hum or growl that rises with speed on the test drive.

One test can record several defects, so this is not the share of LDV Convoys.

Each tip applies only if the car you are looking at has that fault in its own MOT history.

All DVSA descriptions in this group (5)
LDV Convoy: suspension defects recorded at MOTs, 2019–2024, 30 or more each
DVSA descriptionIn plain wordsRecordedPer 100 tests
The strength or continuity of the load bearing structure within 30cm of any sub-frame, spring or suspension component mounting (a 'prescribed area') is significantly reduced or inadequately repairedRust near suspension or subframe mounts99017.16
A suspension pin, bush or joint excessively wornWorn suspension bush or joint2053.55
A king pin loose in the axle beamA king pin loose in the axle beam1712.96
A shock absorber damaged to the extent that it does not function or showing signs of severe leakageShock absorber leaking or failed1462.53
A wheel bearing with excessive playWheel bearing with play1041.8

Download these figures (CSV)

How are these figures calculated?

Defects are counted at first MOT tests, 2019–2024. The expected rate is for vans with the same mix of ages.

The comparison uses 5,768 initial tests. The difference is −6.07 defects per 100 tests (95% interval −7.73 to −4.41).

Full methodology

How to cite these figures

Download the full dataset (CSV) · All models on suspension