Does the Ford Puma have more suspension problems than other cars its age?
Ford Pumas do have suspension problems recorded, but less often than other cars their age.
- per 100 tests
- 0.25 per 100 testsdefects recorded at first MOT tests
Expected for cars of the same age: 0.85 per 100 tests
One test can record several defects, so this is not the share of Ford Pumas.
Data: DVSA MOT results · 2019–2024 · 85,520 tests
Check a Ford Puma by registration
Which suspension problem is recorded most on the Ford Puma?
Rust near suspension or subframe mounts: recorded 4,983 times in 2019–2024, or 5.83 per 100 tests.
The metal near a suspension, spring or subframe mounting is badly rusted, damaged or poorly repaired, which fails the MOT.
What to check: Look under the car around the suspension mountings for rust holes, patch welds or fresh underseal hiding rust.
Check a Ford Puma by registration
Which suspension problems should I check for on a used Ford Puma?
The suspension defects recorded most often on Ford Pumas, 2019–2024, per 100 tests.
- Rust near suspension or subframe mounts5.83Major
What to check: Look under the car around the suspension mountings for rust holes, patch welds or fresh underseal hiding rust.
- Worn suspension bush or joint2.64Major
What to check: Listen for knocks over speed bumps, feel for the car wandering under braking, and ask which part was replaced.
- A stub axle swivel pin and/or bush excessively worn0.74
What to check: Ask the seller what was repaired, and when.
- Shock absorber leaking or failed0.64Major
What to check: Look behind the wheels for oily, wet shock absorbers, and push down hard on each corner: it should rise once and settle.
- Suspension joint cover perished0.59Minor
What to check: Look at the ball joint covers behind the front wheels: once a cover splits, the joint wears out.
One test can record several defects, so this is not the share of Ford Pumas.
Each tip applies only if the car you are looking at has that fault in its own MOT history.
All DVSA descriptions in this group (5)
| DVSA description | In plain words | Recorded | Per 100 tests |
|---|---|---|---|
| The strength or continuity of the load bearing structure within 30cm of any sub-frame, spring or suspension component mounting (a 'prescribed area') is significantly reduced or inadequately repaired | Rust near suspension or subframe mounts | 4,983 | 5.83 |
| A suspension pin, bush or joint excessively worn | Worn suspension bush or joint | 2,262 | 2.64 |
| A stub axle swivel pin and/or bush excessively worn | A stub axle swivel pin and/or bush excessively worn | 635 | 0.74 |
| A shock absorber damaged to the extent that it does not function or showing signs of severe leakage | Shock absorber leaking or failed | 546 | 0.64 |
| A suspension joint dust cover severely deteriorated | Suspension joint cover perished | 508 | 0.59 |
How are these figures calculated?
Defects are counted at first MOT tests, 2019–2024. The expected rate is for cars with the same mix of ages.
The comparison uses 85,520 initial tests. The difference is −0.60 defects per 100 tests (95% interval −0.66 to −0.53).
More on the Ford Puma
- Overview:
- Model overview · All Ford models
- What fails:
- body · brakes · plates · lights · emissions · wheels · seat belts · steering · suspension · tyres · visibility
- By area:
- Postcode areas
- Similar cars on suspension:
- MG HS · Honda Accord
- Group ranking:
- All cars on suspension