Does the Chrysler Crossfire have more suspension problems than other cars its age?
Chrysler Crossfires do have suspension problems recorded, but less often than other cars their age.
- per 100 tests
- 14.48 per 100 testsdefects recorded at first MOT tests
Expected for cars of the same age: 31.72 per 100 tests
One test can record several defects, so this is not the share of Chrysler Crossfires.
Data: DVSA MOT results · 2019–2024 · 13,934 tests
Check a Chrysler Crossfire by registration
How often do suspension advisories on Chrysler Crossfires turn into fails?
14.9% of suspension advisories on Chrysler Crossfires turned into suspension fails at the next MOT.
Typically, the next MOT came 12 months and 2,369 miles later.
Based on 1,901 advisories, each followed to the car's next MOT, 2019–2024. This counts advisories, not cars.
Which suspension problem is recorded most on the Chrysler Crossfire?
Broken or weakened suspension spring: recorded 888 times in 2019–2024, or 6.37 per 100 tests.
A suspension spring, or a bracket that holds it, is broken, cracked or badly weakened, which fails the MOT.
What to check: Look behind each wheel at the coil springs for a snapped end, and check the car sits level from side to side.
Check a Chrysler Crossfire by registration
Which suspension problems should I check for on a used Chrysler Crossfire?
The suspension defects recorded most often on Chrysler Crossfires, 2019–2024, per 100 tests.
- Broken or weakened suspension spring6.37Major
What to check: Look behind each wheel at the coil springs for a snapped end, and check the car sits level from side to side.
- Rust near suspension or subframe mounts3.37Major
What to check: Look under the car around the suspension mountings for rust holes, patch welds or fresh underseal hiding rust.
- Worn suspension bush or joint2.09Major
What to check: Listen for knocks over speed bumps, feel for the car wandering under braking, and ask which part was replaced.
- Wheel bearing with play0.59Major
What to check: Ask whether the bearing was replaced, and listen for a hum or growl that rises with speed on the test drive.
- Suspension joint cover perished0.56Minor
What to check: Look at the ball joint covers behind the front wheels: once a cover splits, the joint wears out.
One test can record several defects, so this is not the share of Chrysler Crossfires.
Each tip applies only if the car you are looking at has that fault in its own MOT history.
All DVSA descriptions in this group (5)
| DVSA description | In plain words | Recorded | Per 100 tests |
|---|---|---|---|
| A spring or spring component fractured or seriously weakened | Broken or weakened suspension spring | 888 | 6.37 |
| The strength or continuity of the load bearing structure within 30cm of any sub-frame, spring or suspension component mounting (a 'prescribed area') is significantly reduced or inadequately repaired | Rust near suspension or subframe mounts | 469 | 3.37 |
| A suspension pin, bush or joint excessively worn | Worn suspension bush or joint | 291 | 2.09 |
| A wheel bearing with excessive play | Wheel bearing with play | 82 | 0.59 |
| A suspension joint dust cover severely deteriorated | Suspension joint cover perished | 78 | 0.56 |
How are these figures calculated?
Defects are counted at first MOT tests, 2019–2024. The expected rate is for cars with the same mix of ages.
The comparison uses 13,934 initial tests. The difference is −17.24 defects per 100 tests (95% interval −18.18 to −16.31).
More on the Chrysler Crossfire
- Overview:
- Model overview · All Chrysler models
- What fails:
- body · brakes · plates · lights · emissions · wheels · seat belts · steering · suspension · tyres · visibility
- By area:
- Postcode areas
- Similar cars on suspension:
- Audi RS6 · Morgan Plus 4
- Group ranking:
- All cars on suspension