Does the Chrysler 300 have more brake problems than other cars its age?

Chrysler 300s have brake problems recorded more often than other cars their age.

per 100 tests
35.75 per 100 testsdefects recorded at first MOT tests

Expected for cars of the same age: 17.38 per 100 tests

One test can record several defects, so this is not the share of Chrysler 300s.

Data: DVSA MOT results · 2019–2024 · 11,016 tests

Check a Chrysler 300 by registration

How often do brake advisories on Chrysler 300s turn into fails?

21.4% of brake advisories on Chrysler 300s turned into brake fails at the next MOT.

Typically, the next MOT came 12 months and 3,807 miles later.

Based on 2,342 advisories, each followed to the car's next MOT, 2019–2024. This counts advisories, not cars.

Which brake problem is recorded most on the Chrysler 300?

Handbrake too weak: recorded 775 times in 2019–2024, or 7.04 per 100 tests.

The handbrake did not hold strongly enough on the brake tester, which fails the MOT.

What to check: Check the handbrake holds the car on a steep slope without the lever rising to the top of its travel.

Check a Chrysler 300 by registration

For example, AB12 CDE

Before you submit. Enter a UK registration to compare this vehicle with similar cars: statistical information, not vehicle condition advice. It goes to the DVSA MOT History API, never into URLs or analytics, and any cache expires within 15 minutes. MOT history is free on GOV.UK and we do not sell it; read how we use your data.

Free to use. Independent site. Not affiliated with DVSA, DVLA or GOV.UK.

Which brake problems should I check for on a used Chrysler 300?

The brake defects recorded most often on Chrysler 300s, 2019–2024, per 100 tests.

  • Handbrake too weak7.04
    Major

    What to check: Check the handbrake holds the car on a steep slope without the lever rising to the top of its travel.

  • Handbrake under half its required force6.74
    Dangerous

    What to check: Ask what was repaired, such as cables, rear calipers or the electric motor, and test the handbrake on a slope.

  • Handbrake working on one side only5.37
    Major

    What to check: Ask whether a handbrake cable or rear caliper was replaced, and check the handbrake holds the car on a slope.

  • Brake dragging when released2.71
    Major

    What to check: Check the car rolls freely when coasting and does not pull to one side.

  • ABS or brake warning light on2.27
    Major

    What to check: Check the ABS light goes out after start-up and stays out on the test drive.

One test can record several defects, so this is not the share of Chrysler 300s.

Each tip applies only if the car you are looking at has that fault in its own MOT history.

All DVSA descriptions in this group (5)
Chrysler 300: brake defects recorded at MOTs, 2019–2024, 30 or more each
DVSA descriptionIn plain wordsRecordedPer 100 tests
Parking brake efficiency below minimum requirementHandbrake too weak7757.04
Parking brake efficiency less than 50% of the required valueHandbrake under half its required force7436.74
Parking brake inoperative on one sideHandbrake working on one side only5925.37
Significant brake effort recorded with no brake applied indicating a binding brakeBrake dragging when released2992.71
Warning device shows system malfunctionABS or brake warning light on2502.27

Download these figures (CSV)

How are these figures calculated?

Defects are counted at first MOT tests, 2019–2024. The expected rate is for cars with the same mix of ages.

The comparison uses 11,016 initial tests. The difference is +18.37 defects per 100 tests (95% interval +17.25 to +19.48).

Full methodology

How to cite these figures

Download the full dataset (CSV) · All models on brakes