Does the Bentley Turbo have more brake problems than other cars its age?

Bentley Turbos do have brake problems recorded, but less often than other cars their age.

per 100 tests
17.3 per 100 testsdefects recorded at first MOT tests

Expected for cars of the same age: 20.98 per 100 tests

One test can record several defects, so this is not the share of Bentley Turbos.

Data: DVSA MOT results · 2019–2024 · 5,388 tests

Check a Bentley Turbo by registration

How often do brake advisories on Bentley Turbos turn into fails?

14.1% of brake advisories on Bentley Turbos turned into brake fails at the next MOT.

Typically, the next MOT came 12 months and 706 miles later.

Based on 567 advisories, each followed to the car's next MOT, 2019–2024. This counts advisories, not cars.

Which brake problem is recorded most on the Bentley Turbo?

Handbrake too weak: recorded 201 times in 2019–2024, or 3.73 per 100 tests.

The handbrake did not hold strongly enough on the brake tester, which fails the MOT.

What to check: Check the handbrake holds the car on a steep slope without the lever rising to the top of its travel.

Check a Bentley Turbo by registration

For example, AB12 CDE

Before you submit. Enter a UK registration to compare this vehicle with similar cars: statistical information, not vehicle condition advice. It goes to the DVSA MOT History API, never into URLs or analytics, and any cache expires within 15 minutes. MOT history is free on GOV.UK and we do not sell it; read how we use your data.

Free to use. Independent site. Not affiliated with DVSA, DVLA or GOV.UK.

Which brake problems should I check for on a used Bentley Turbo?

The brake defects recorded most often on Bentley Turbos, 2019–2024, per 100 tests.

  • Handbrake too weak3.73
    Major

    What to check: Check the handbrake holds the car on a steep slope without the lever rising to the top of its travel.

  • Handbrake under half its required force2.56
    Dangerous

    What to check: Ask what was repaired, such as cables, rear calipers or the electric motor, and test the handbrake on a slope.

  • Handbrake working on one side only1.47
    Major

    What to check: Ask whether a handbrake cable or rear caliper was replaced, and check the handbrake holds the car on a slope.

  • Brake pipe rusted or damaged1.39
    Major

    What to check: Look along the underside at the metal brake pipes for flaking rust, and ask whether they were renewed.

  • Actuator leaking and braking performance not affected1.24

    What to check: Ask the seller what was repaired, and when.

One test can record several defects, so this is not the share of Bentley Turbos.

Each tip applies only if the car you are looking at has that fault in its own MOT history.

All DVSA descriptions in this group (5)
Bentley Turbo: brake defects recorded at MOTs, 2019–2024, 30 or more each
DVSA descriptionIn plain wordsRecordedPer 100 tests
Parking brake efficiency below minimum requirementHandbrake too weak2013.73
Parking brake efficiency less than 50% of the required valueHandbrake under half its required force1382.56
Parking brake inoperative on one sideHandbrake working on one side only791.47
Brake pipe damaged or excessively corrodedBrake pipe rusted or damaged751.39
Actuator leaking and braking performance not affectedActuator leaking and braking performance not affected671.24

Download these figures (CSV)

How are these figures calculated?

Defects are counted at first MOT tests, 2019–2024. The expected rate is for cars with the same mix of ages.

The comparison uses 5,388 initial tests. The difference is −3.68 defects per 100 tests (95% interval −4.91 to −2.46).

Full methodology

How to cite these figures

Download the full dataset (CSV) · All models on brakes