Does the Audi Coupe have more suspension problems than other cars its age?

Audi Coupes do have suspension problems recorded, but less often than other cars their age.

per 100 tests
16.79 per 100 testsdefects recorded at first MOT tests

Expected for cars of the same age: 20.60 per 100 tests

One test can record several defects, so this is not the share of Audi Coupes.

Data: DVSA MOT results · 2019–2024 · 4,063 tests

Check an Audi Coupe by registration

How often do suspension advisories on Audi Coupes turn into fails?

12.6% of suspension advisories on Audi Coupes turned into suspension fails at the next MOT.

Typically, the next MOT came 12 months and 1,289 miles later.

Based on 754 advisories, each followed to the car's next MOT, 2019–2024. This counts advisories, not cars.

Which suspension problem is recorded most on the Audi Coupe?

Worn suspension bush or joint: recorded 214 times in 2019–2024, or 5.27 per 100 tests.

A suspension bush, pin or ball joint has worn loose, which makes the handling vague and fails the MOT.

What to check: Listen for knocks over speed bumps, feel for the car wandering under braking, and ask which part was replaced.

Check an Audi Coupe by registration

For example, AB12 CDE

Before you submit. Enter a UK registration to compare this vehicle with similar cars: statistical information, not vehicle condition advice. It goes to the DVSA MOT History API, never into URLs or analytics, and any cache expires within 15 minutes. MOT history is free on GOV.UK and we do not sell it; read how we use your data.

Free to use. Independent site. Not affiliated with DVSA, DVLA or GOV.UK.

Which suspension problems should I check for on a used Audi Coupe?

The suspension defects recorded most often on Audi Coupes, 2019–2024, per 100 tests.

  • Worn suspension bush or joint5.27
    Major

    What to check: Listen for knocks over speed bumps, feel for the car wandering under braking, and ask which part was replaced.

  • Suspension joint cover perished2.14
    Minor

    What to check: Look at the ball joint covers behind the front wheels: once a cover splits, the joint wears out.

  • Rust near suspension or subframe mounts1.90
    Major

    What to check: Look under the car around the suspension mountings for rust holes, patch welds or fresh underseal hiding rust.

  • Suspension joint cover split or missing1.58
    Major

    What to check: Ask whether the ball joint was replaced along with its cover: a joint that ran unprotected wears quickly and knocks over bumps.

  • Wheel bearing with play1.16
    Major

    What to check: Ask whether the bearing was replaced, and listen for a hum or growl that rises with speed on the test drive.

One test can record several defects, so this is not the share of Audi Coupes.

Each tip applies only if the car you are looking at has that fault in its own MOT history.

All DVSA descriptions in this group (5)
Audi Coupe: suspension defects recorded at MOTs, 2019–2024, 30 or more each
DVSA descriptionIn plain wordsRecordedPer 100 tests
A suspension pin, bush or joint excessively wornWorn suspension bush or joint2145.27
A suspension joint dust cover severely deterioratedSuspension joint cover perished872.14
The strength or continuity of the load bearing structure within 30cm of any sub-frame, spring or suspension component mounting (a 'prescribed area') is significantly reduced or inadequately repairedRust near suspension or subframe mounts771.9
A suspension joint dust cover missing or no longer prevents the ingress of dirt etcSuspension joint cover split or missing641.58
A wheel bearing with excessive playWheel bearing with play471.16

Download these figures (CSV)

How are these figures calculated?

Defects are counted at first MOT tests, 2019–2024. The expected rate is for cars with the same mix of ages.

The comparison uses 4,063 initial tests. The difference is −3.81 defects per 100 tests (95% interval −5.21 to −2.42).

Full methodology

How to cite these figures

Download the full dataset (CSV) · All models on suspension