Does the Saab 9000 have more suspension problems than other cars its age?

Saab 9000s have suspension problems recorded about as often as other cars their age.

per 100 tests
24.41 per 100 testsdefects recorded at first MOT tests

Expected for cars of the same age: 23.88 per 100 tests

One test can record several defects, so this is not the share of Saab 9000s.

Data: DVSA MOT results · 2019–2024 · 5,043 tests

Check a Saab 9000 by registration

How often do suspension advisories on Saab 9000s turn into fails?

18.1% of suspension advisories on Saab 9000s turned into suspension fails at the next MOT.

Typically, the next MOT came 12 months and 2,452 miles later.

Based on 993 advisories, each followed to the car's next MOT, 2019–2024. This counts advisories, not cars.

Which suspension problem is recorded most on the Saab 9000?

Rust near suspension or subframe mounts: recorded 521 times in 2019–2024, or 10.33 per 100 tests.

The metal near a suspension, spring or subframe mounting is badly rusted, damaged or poorly repaired, which fails the MOT.

What to check: Look under the car around the suspension mountings for rust holes, patch welds or fresh underseal hiding rust.

Check a Saab 9000 by registration

For example, AB12 CDE

Before you submit. Enter a UK registration to compare this vehicle with similar cars: statistical information, not vehicle condition advice. It goes to the DVSA MOT History API, never into URLs or analytics, and any cache expires within 15 minutes. MOT history is free on GOV.UK and we do not sell it; read how we use your data.

Free to use. Independent site. Not affiliated with DVSA, DVLA or GOV.UK.

Which suspension problems should I check for on a used Saab 9000?

The suspension defects recorded most often on Saab 9000s, 2019–2024, per 100 tests.

  • Rust near suspension or subframe mounts10.33
    Major

    What to check: Look under the car around the suspension mountings for rust holes, patch welds or fresh underseal hiding rust.

  • Worn suspension bush or joint9.16
    Major

    What to check: Listen for knocks over speed bumps, feel for the car wandering under braking, and ask which part was replaced.

  • Suspension part rusted or damaged1.27
    Major

    What to check: Look under the car at the suspension arms and anti-roll bar for flaking rust, or bends from hitting a kerb.

  • Broken or weakened suspension spring1.05
    Major

    What to check: Look behind each wheel at the coil springs for a snapped end, and check the car sits level from side to side.

One test can record several defects, so this is not the share of Saab 9000s.

Each tip applies only if the car you are looking at has that fault in its own MOT history.

All DVSA descriptions in this group (4)
Saab 9000: suspension defects recorded at MOTs, 2019–2024, 30 or more each
DVSA descriptionIn plain wordsRecordedPer 100 tests
The strength or continuity of the load bearing structure within 30cm of any sub-frame, spring or suspension component mounting (a 'prescribed area') is significantly reduced or inadequately repairedRust near suspension or subframe mounts52110.33
A suspension pin, bush or joint excessively wornWorn suspension bush or joint4629.16
A suspension component excessively damaged or corrodedSuspension part rusted or damaged641.27
A spring or spring component fractured or seriously weakenedBroken or weakened suspension spring531.05

Download these figures (CSV)

How are these figures calculated?

Defects are counted at first MOT tests, 2019–2024. The expected rate is for cars with the same mix of ages.

The comparison uses 5,043 initial tests. The difference is +0.53 defects per 100 tests (95% interval −0.83 to +1.89).

Full methodology

How to cite these figures

Download the full dataset (CSV) · All models on suspension