Does the Bentley Continental have more brake problems than other cars its age?

Bentley Continentals do have brake problems recorded, but less often than other cars their age.

per 100 tests
2.65 per 100 testsdefects recorded at first MOT tests

Expected for cars of the same age: 14.64 per 100 tests

One test can record several defects, so this is not the share of Bentley Continentals.

Data: DVSA MOT results · 2019–2024 · 82,175 tests

Check a Bentley Continental by registration

How often do brake advisories on Bentley Continentals turn into fails?

5.5% of brake advisories on Bentley Continentals turned into brake fails at the next MOT.

Typically, the next MOT came 12 months and 1,690 miles later.

Based on 4,465 advisories, each followed to the car's next MOT, 2019–2024. This counts advisories, not cars.

Which brake problem is recorded most on the Bentley Continental?

Brake dragging when released: recorded 301 times in 2019–2024, or 0.37 per 100 tests.

The brake tester measured braking force with the brakes off, so a brake is binding, which fails the MOT.

What to check: Check the car rolls freely when coasting and does not pull to one side.

Check a Bentley Continental by registration

For example, AB12 CDE

Before you submit. Enter a UK registration to compare this vehicle with similar cars: statistical information, not vehicle condition advice. It goes to the DVSA MOT History API, never into URLs or analytics, and any cache expires within 15 minutes. MOT history is free on GOV.UK and we do not sell it; read how we use your data.

Free to use. Independent site. Not affiliated with DVSA, DVLA or GOV.UK.

Which brake problems should I check for on a used Bentley Continental?

The brake defects recorded most often on Bentley Continentals, 2019–2024, per 100 tests.

  • Brake dragging when released0.37
    Major

    What to check: Check the car rolls freely when coasting and does not pull to one side.

  • Brake pads or shoes dangerously thin0.36
    Dangerous

    What to check: Look through the wheels at the pads and discs, listen for grinding, and ask when they were last replaced.

  • Stability control warning light on0.27
    Major

    What to check: Check the stability control light goes out after start-up and stays out on the test drive.

  • Handbrake too weak0.26
    Major

    What to check: Check the handbrake holds the car on a steep slope without the lever rising to the top of its travel.

  • Brake discs or drums worn0.15
    Major

    What to check: Look for a deep lip on the outer edge of the brake discs and feel for judder through the pedal when braking.

One test can record several defects, so this is not the share of Bentley Continentals.

Each tip applies only if the car you are looking at has that fault in its own MOT history.

All DVSA descriptions in this group (5)
Bentley Continental: brake defects recorded at MOTs, 2019–2024, 30 or more each
DVSA descriptionIn plain wordsRecordedPer 100 tests
Significant brake effort recorded with no brake applied indicating a binding brakeBrake dragging when released3010.37
a brake lining or pad worn below 1.5mmBrake pads or shoes dangerously thin2920.36
ESC MIL indicates a system malfunctionStability control warning light on2250.27
Parking brake efficiency below minimum requirementHandbrake too weak2150.26
Brake disc or drum significantly and obviously wornBrake discs or drums worn1220.15

Download these figures (CSV)

How are these figures calculated?

Defects are counted at first MOT tests, 2019–2024. The expected rate is for cars with the same mix of ages.

The comparison uses 82,175 initial tests. The difference is −11.99 defects per 100 tests (95% interval −12.25 to −11.73).

Full methodology

How to cite these figures

Download the full dataset (CSV) · All models on brakes